You have to know the importance of screen seals when you have a glass shower screen in your bathroom. Other than providing some sort of protection, they keep water inside and prevent slippery puddles outside the bath area.
Sure, when you got your new screen, the contractor did install the seal correctly. But according to Perth City Glass, these things also experience wear and tear, thus the need for occasional replacements. When you want to do this by yourself, you need to know how to do it right.
Here’s a guide on installing shower screen seals properly:
• Make sure you have all the tools and the required materials necessary. Do allot enough time to complete the project.
• Remove the old seal very carefully. If you simply tear the old screen, no matter what you do, you won’t be able to install the new shower screen seal properly. Remove each part of the old seal – this means dealing with those tiny bits of the dried out adhesive as well.
Clip-on type seals are really easy to remove, as all you need to do is unclip it and then slide it off. Otherwise, you may have to use a straight razor or a Stanley knife and then rub off the grease or adhesive using rubbing alcohol.
• Measure your new shower screen seal. Although this might seem easy, it is something that can cause quite a headache if you don’t pay attention. Measure from the inside of the shower glass all the time – and do so with precision.
• Cut your seal where you have marked it. For this, it is best to place the seal on a flat surface and then use a Stanley knife to slice it off. • Lastly, fix the seal in place. If it is a clip-on type, simply attach it on the door starting at the bottom.
Take care not to slide it to avoid any damage. In case your seal has needs silicone gel to stick, it could be quite a tough job.
Nonetheless, the installation guide of the seal will surely guide you properly. It’s not so difficult to install a shower screen seal, provided that you know how to do it right. Follow this guide and surely you would be done in no time.